2.4.1 String literals

String literals are described by the following lexical definitions:

stringliteral:   shortstring | longstring
shortstring:     "'" shortstringitem* "'" | '"' shortstringitem* '"'
longstring:      "'''" longstringitem* "'''" | '"""' longstringitem* '"""'
shortstringitem: shortstringchar | escapeseq
longstringitem:  longstringchar | escapeseq
shortstringchar: <any ASCII character except "\" or newline or the quote>
longstringchar:  <any ASCII character except "\">
escapeseq:       "\" <any ASCII character>
 

In plain English: String literals can be enclosed in matching single quotes (') or double quotes ("). They can also be enclosed in matching groups of three single or double quotes (these are generally referred to as triple-quoted strings). The backslash (\) character is used to escape characters that otherwise have a special meaning, such as newline, backslash itself, or the quote character. String literals may optionally be prefixed with a letter `r' or `R'; such strings are called raw strings and use different rules for backslash escape sequences. A prefix of 'u' or 'U' makes the string a Unicode string. Unicode strings use the Unicode character set as defined by the Unicode Consortium and ISO 10646. Some additional escape sequences, described below, are available in Unicode strings.

In triple-quoted strings, unescaped newlines and quotes are allowed (and are retained), except that three unescaped quotes in a row terminate the string. (A ``quote'' is the character used to open the string, i.e. either ' or ".)

Unless an `r' or `R' prefix is present, escape sequences in strings are interpreted according to rules similar to those used by Standard C. The recognized escape sequences are:

Escape Sequence  Meaning 
\newline Ignored
\\ Backslash (\)
\' Single quote (')
\" Double quote (")
\a ASCII Bell (BEL)
\b ASCII Backspace (BS)
\f ASCII Formfeed (FF)
\n ASCII Linefeed (LF)
\N{name} Character with 16-bit hex value xxxx (Unicode only)
\r ASCII Carriage Return (CR)
\t ASCII Horizontal Tab (TAB)
\uxxxx Character with 32-bit hex value xxxxxxxx (Unicode only)
\Uxxxxxxxx ASCII@ASCII
\v ASCII Vertical Tab (VT)
\ooo ASCII character with octal value ooo
\xhh ASCII character with hex value hh

As in Standard C, up to three octal digits are accepted. However, exactly two hex digits are taken in hex escapes.

Unlike Standard  , all unrecognized escape sequences are left in the string unchanged, i.e., the backslash is left in the string. (This behavior is useful when debugging: if an escape sequence is mistyped, the resulting output is more easily recognized as broken.) It is also important to note that the escape sequences marked as ``(Unicode only)'' in the table above fall into the category of unrecognized escapes for non-Unicode string literals.

When an `r' or `R' prefix is present, a character following a backslash is included in the string without change, and all backslashes are left in the string. For example, the string literal r"\n" consists of two characters: a backslash and a lowercase `n'. String quotes can be escaped with a backslash, but the backslash remains in the string; for example, r"\"" is a valid string literal consisting of two characters: a backslash and a double quote; r"\" is not a value string literal (even a raw string cannot end in an odd number of backslashes). Specifically, a raw string cannot end in a single backslash (since the backslash would escape the following quote character). Note also that a single backslash followed by a newline is interpreted as those two characters as part of the string, not as a line continuation.

See About this document... for information on suggesting changes.